Why Does My Recording Have a Hum or Hiss? (And How to Remove It)
How to remove hum and hiss from audio, with numbers: we added both to a clean voice, ran seven common fixes and measured what each one left between the words.
By Facecam team
Published · 7 min read

On this page
Short answer
Hum is electrical: a steady 50 or 60 Hz tone and its multiples, usually from a ground loop, a charger or a cable near power. Hiss is the electronics' own noise, made louder by high mic gain. In our test, notch filters only worked at the right mains frequency and did nothing for hiss; an AI noise remover cleared both, taking the noise between words from -27 dB to -42 dB below the voice.
Most guides say three things: hum is 50 or 60 Hz, use a notch filter, try Audacity's noise reduction. None we read on 17 October showed what those fixes leave behind, so we built the problem on purpose and measured.
What's the difference between hum and hiss?
Hum is a low, steady tone; hiss is a soft, even rush like air from a tyre. They come from different places, so they need different fixes, and a recording often has both.
- Hum comes from the mains power. It sits at 60 Hz in the US, Canada, Mexico and Brazil, and at 50 Hz in the UK, Europe, India, China and Australia. Japan has both: 50 Hz in the east (Tokyo), 60 Hz in the west. It never comes alone: there are copies at 120, 180, 240 Hz and up, which is why it sounds like a drone, not a pure note.
- Buzz is hum with a lot more of those copies, reaching into the kHz range. Dimmers, cheap chargers and badly shielded cables make it. It sounds harsher and is harder to filter out.
- Hiss is the noise every circuit makes, spread across all frequencies. Turning the mic gain up raises it, and you hear it most between words.

Why does my recording hum?
Almost always because of power. A ground loop happens when two pieces of gear are plugged into different sockets and connected by an audio cable: the cable carries a small mains current, and your mic records it. A laptop on its charger, a USB mic on a powered hub, or a mic cable lying across a power lead do the same.
Find the source before you fix the file. Record ten seconds of silence after each change below. The first change that makes the hum stop is your cause.
Run the laptop on battery
Unplug the charger and record again. If the hum stops, the charger or its socket is the cause; try another socket or a charger with an earth pin.
Plug everything into one socket
Computer, interface, speakers and lights on one power strip removes most ground loops.
Move the cables
Keep the mic cable away from power leads and power bricks. If they have to cross, cross them at a right angle.
Try another USB port
Use a port straight on the computer, not a hub. If one port hums, record again on another.
Why does my recording hiss?
Because the gain is doing the work your voice should do. If you sit far from the mic and turn the gain up to compensate, the hiss comes up with you. Move closer, about a hand's width away, and lower the gain until your loudest words peak a little below the top. Turn off any automatic gain in your recording app too: it raises the hiss in every pause.
A mic test shows this in a minute. Mic Test is a free browser tool that shows your microphone's input level and plays back a short recording. Our post on why a mic sounds bad explains how to read the levels.
What removes hum and hiss from a recording?
An AI noise remover took out both in our test; plain filters only handled hum, and only at the right frequency. The table shows the noise left in the pauses between sentences, measured against the voice; a bigger number means a quieter gap. For reference, our voiceover with no noise added measures -41 dB.
| Fix | 60 Hz hum | 50 Hz hum | Buzz | Hiss | Hum + hiss |
|---|---|---|---|---|---|
| Nothing (original) | -28 dB | -28 dB | -30 dB | -32 dB | -27 dB |
| High-pass at 100 Hz | -33 dB | -34 dB | -32 dB | -32 dB | -29 dB |
| One notch at 60 Hz | -33 dB | -29 dB | -32 dB | -32 dB | -30 dB |
| Notches at 60 to 360 Hz | -37 dB | -27 dB | -33 dB | -30 dB | -30 dB |
| FFmpeg noise reduction (afftdn) | -29 dB | -28 dB | -32 dB | -41 dB | -31 dB |
| Voice Isolator, free clean | -40 dB | -43 dB | -46 dB | -46 dB | -42 dB |
| Voice Isolator, HD clean | -37 dB | -43 dB | -45 dB | -44 dB | -37 dB |
Three things stood out. First, a 60 Hz notch on 50 Hz hum did nothing (-28 dB before, -29 dB after), so check which mains frequency you live on before you filter. Second, filters didn't touch hiss at all, and even six notches only took buzz from -30 dB to -33 dB, because buzz has copies far above 360 Hz. Third, FFmpeg's noise reduction helped with hiss (-41 dB) but left hum where it was.
Original: 60 Hz hum and hiss
Notches at 60 to 360 Hz
Voice Isolator, free clean
Voice Isolator, HD clean
50 Hz hum with a 60 Hz notch (no change)
Is the hum gone under the words too?
Not fully with the free clean. Between words it is very quiet, partly because it also turns the gaps down by up to 12 dB. Under the words, though, the 60 Hz tone dropped only 5 dB, and you can see faint hum lines in the figure above. The HD clean took it down 14 dB and a set of notch filters 15 dB.
The fix that worked: notches first, then the free clean. That took the hum under the words down 14 dB and left the pauses at -38 dB, close to the clean voice. Hiss behaved the other way round: the free clean lowered it 6 dB under the words, while in the HD version the high frequencies look almost like the clean voice.
FFmpeg: notches at 60 Hz and five copies (use 50, 100 … 300 for 50 Hz hum)
ffmpeg -i in.wav -af "bandreject=f=60:width_type=q:width=8,bandreject=f=120:width_type=q:width=8,bandreject=f=180:width_type=q:width=8,bandreject=f=240:width_type=q:width=8,bandreject=f=300:width_type=q:width=8,bandreject=f=360:width_type=q:width=8" out.wavHow do I clean hum and hiss for free?
Voice Isolator is a free browser tool that removes background noise from a recording and leaves your voice, with an optional HD pass for tougher noise. The free clean runs on your device, so nothing is uploaded.
Fix the source first
Charger, sockets, cables and gain, as above. A cleaner can't bring back words the noise covered.
For strong hum, notch it first
With Audacity's Notch Filter effect or with the FFmpeg line above, at 50 or 60 Hz and the next five multiples.
Open Voice Isolator and upload the file
WAV, MP3, M4A, OGG, WebM or FLAC, up to 10 minutes. A 17-second clip took 0.53 to 0.65 seconds in our test (1.4 s the first time, while the noise model loaded).
Compare, then download
Switch between Before and Cleaned at the same spot, then press Download WAV. For free visitors, the file ends with a two-second spoken Facecam tag.
Still noisy? Try HD
Clean in HD needs an account and a paid plan. It costs 25 credits per started minute, for files up to 5 minutes. Our clips took 2.3 to 5.6 seconds on the model and came back as MP3s about 25 ms behind the original.
If music or a second person is behind your voice, that's a different job: see how to remove music from a video.
What didn't we test?
- Real mics. We mixed steady, made-up noise into an AI voice. Real hum drifts a little and real hiss changes with the room, so your numbers will differ from ours.
- Listening panels. Our numbers are levels and spectrograms, not people rating the sound.
- Noise louder than the voice. Ours sat 27 to 32 dB under the voice. If the hum is about as loud as you are, re-record.
- Paid plug-ins like CEDAR or iZotope. They may do better on hum than a general noise remover; we only tested free filters and our own tool.
Questions
How do I know if my hum is 50 Hz or 60 Hz?
It matches your mains power: 60 Hz in North America, 50 Hz in the UK, Europe, India and Australia, and either one in Japan depending on the region. A spectrum view in Audacity shows the lowest flat line, which is the one to notch.
Can Audacity remove hum?
Yes. Its Notch Filter handles steady hum if you notch the mains frequency and a few of its multiples, and its Noise Reduction handles hiss after you give it a second of noise alone. In our test, filters on their own did nothing for hiss.
Does a high-pass filter remove hum?
Only partly. A high-pass at 100 Hz cut the 60 Hz tone but left its copies at 120 Hz and up; in our test the hum between words went from -28 dB to -33 dB below the voice, against -40 dB with an AI noise remover.
Is hiss from my mic or my room?
Record ten seconds of silence at your usual gain, then ten more with the mic pressed into a pillow. If the hiss is just as loud the second time, it comes from the mic or the interface, not the room.
Keep reading

Voice
How to Do a Movie Trailer Voice: Pace, Pauses and Pitch
How to do a movie trailer voice with your own mic: how to read the line, then what a free preset and an AI narrator voice add, measured on the same take.
8 min read

Voice
How to Do NPC Voices as a DM (Without Wrecking Your Throat)
How to do NPC voices for a whole session: what to change yourself, what a voice changer can carry for you, and what we measured when we ran nine fantasy voices through a call codec.
7 min read

Voice
How to Find the Key of a Song You're Singing
How to find the key of a song by ear or with a free key finder, and what we learned running three AI-made vocals through one: how long to sing, and why the answer is sometimes the 'wrong' key with the right notes.
7 min read
Free, in your browser
Voice Isolator
Voice Isolator is a free browser tool that removes background noise from a recording and leaves your voice, with an optional HD pass for tougher noise.
Open Voice Isolator